Video about how to remove door handle on Ford Mondeo MK4 but should be the same on any Ford car of 2007-2013 make.Door Card removal starts at 04.26Part 2 - h The 2020 Ford Escape has 1 problems reported for drivers door locked randomly. Average failure mileage is 2,900 miles. All UK made Mondeo's have central locking, an alarm, immobiliser and double locking as standard. Optional equipment included remote central locking, interior scanning and glass breakage sensors (Estate only). There are a number of problems you can encounter with the earlier Mondeo's alarm system. Most involve one or more parts of the system You can either a) Open and close a door numerous times in quick succession until the alarm chirps (trust me!) or b) open the bonnet and look for a switch near the front of the car. It goes in when the bonnet is closed and is probably encased in rubber. Press that loads of times until the alarm chirps briefly. I have a 2012 titx 2.0 163. I've tried to enable auto locking but it's failed. Following instructions above I did the following; (can't remember the exact wording) Read BCM, in central config change to "locking with speed" I think on page 2 and "auto re-locking" I think on page 5. Save the file then write to BCM and then write to IPC. Release the buttons. Lock the car using the remote. Press UNLOCK button once. Drivers door should unlock, leaving rest of the doors and the trunk locked. Second press will unlock rest of the doors and the trunk. Repeat the procedure to disable this feature. This procedure is proved work in other Ford cars. 8uC22n6. SOURCE: 2002 door locks failed ford escape. Using a multimeter, check for voltage at the lock/unlock solenoid. Disconnect the connector and probe the unlock side with the other lead on a good ground. Hit the unlock twice and see if you get voltage. If yes, the solenoid may be defective or if not, you could possibly have a bad relay. At this point, it's strongly recommended to get an extra pair of hands to assist holding the door window. * Slacken off the window clamp nuts. * Remove the mounting screws for the mechanism. * Now unplug the wire to the electric window motor. Less common causes are bad axle, worn suspension or steering parts or incorrect tire pressure. 1. Unbalanced wheels. The leading cause of steering wheel vibration in Ford Mondeo, especially when driving at high speeds, is unbalanced wheels. If only front wheels are out of balance, the vibration is typically strongest at the steering wheel. I have a 2001 Ford Mondeo (Mk3) 1.8l petrol station wagon with a remote locking problem (as described in this forum earlier) where the remote (central) lock system is living its own life. I also have a ghost drain on my battery (5.5A when the car is turned off) and I belive these two problems are dancing tango with eachother. In colder climates or specific conditions, the door lock mechanism of your Mondeo can freeze or become jammed, preventing the door from opening even when using the exterior handle. Applying a de-icing agent or penetrating oil can help alleviate the lock’s condition and allow the door to open. yep, thats the bit* & the faulty bit thats causing the problem is the electronic bit behind there though but its one unit. * although i would say that the one piccied there is a rear door unit personally as there is only one external lever on the right hand side, the drivers door unit should have 2 ( external handle & lock mechanism )

ford mondeo door lock problem